User's Manual

Diaphragm Meter Installation
8. Verify the encoder cable is in the cable slot of the gasket. Fully tighten the screws in an alternating
fashion. If required, install utility-approved security wire seals.
100G series remote gas module encoder/index installation is complete.
Programming the Remote ERT Module
Caution You must program the 100G series remote gas module before use.
Program the 100G, 100G DL, 100G DLN, and 100G DLT ERT modules using:
• An FC200SR handheld computer with Field Deployment Manager (FDM) software version 1.1 or higher
or
• A FC300 with SRead handheld computer with Field Deployment Manager (FDM) software version 1.1 or
higher or
• A 900MHz Belt Clip Radio with Field Deployment Manager (FDM) software version 1.1 or higher and a
customer-supplied laptop. The Belt Clip Radio connects to the user-supplied laptop using a USB cable or
Bluetooth.
TDC-0824-014 100G Series Gas ERT Module Installation Guide, Remote Mount 86
Proprietary and Confidential