User's Manual

Electronic Volume Corrector and Instrument Installation
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 37
Proprietary and Confidential
The blue and white wires are twisted together and attached according to Mercury Instrument's Code Settings
(see Code Settings on page 35).
To wire the ERT module to the Mercury Instrument
1. Insert the ERT module cable into the instrument's compression connector.
2. Strip one inch of the outer insulation from the 100G Datalogging FN remote ERT module. Strip 1/4-inch
individual wire insulation from the red, white, and blue lead wires.
A White wire
B Blue wire
C Red wire
Caution Keep wires away from the rotating magnetic spindle in the Mercury Instrument.