User's Manual

Rotary Meter Installation

TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 25

Proprietary and Confidential

4. Connect the meter cable to the 100G Datalogging FN remote ERT module using 3M gel-cap connectors.

Follow the wire connection table and wiring diagrams below. See Installation Prerequisites on page 5 for

appropriate 3M crimping tools.

Important Use a crimping tool compatible with gel-connectors. Do not use a standard pliers for crimping

gel-connects. The crimping tool provides an even pressured crimp to make a secure connection. Apply

pressure for three seconds until the gel cap is fully crimped (collapsed) to allow time for the low viscosity

silicone-based gel to flow. If the silicone gel flows out of the crimped connector, avoid touching the gel.

Gel flowing from the connector provides environmental protection for the connection.

American RPM Meter to Datalogging FN remote ERT module Wire Connections

American RPM Meter wire

100G Datalogging FN remote mount ERT module wire

Red

White

Black

Blue