User's Manual

Rotary Meter Installation
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 24
Proprietary and Confidential
To connect the manufacturer cable to the ERT module
Note Connection to an Elster American Meter requires a cable interface compatible to an Elster
American Meter RPM rotary meter.
1. Trim the ERT module wires to 3.5-inches.
2. Carefully strip the insulation covering from the meter cable (purchased from the meter manufacturer)
approximately 1-1/2-inches from the end.
Caution Do not cut through the individual wire insulation.
3. Separate the black, white, and blue wires for connection to the Datalogging FN remote ERT module. Cut
off the unused wires even with the outer covering (insulation).
Caution Do not strip the individual wires.