User's Manual

Rotary Meter Installation
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 18
Proprietary and Confidential
To connect the 100G Datalogging FN remote ERT module cable assembly to the rotary meter
Caution Verify the cable connector mates with the meter connector. Meter manufacturers use different
connector styles (types).
1. Align the large lug on the 100G Datalogging FN remote ERT module connector with the large notch on
the meter connector.
2. Align the lock ring notches on the module cable connector with the pins on the meter connector.
3. Hold the lock ring on the module connector back and push the plug into the meter connector until it is
securely seated.
4. Turn the lock ring clockwise as far as it will go. You will feel it snap into place when it locks.
Warning To remove the module connector plug from the meter connector jack, push in on the lock ring,
turn the lock ring counterclockwise as far as possible, and pull out the plug body. Do not pull on the
module's connector cable.