User's Manual

Mounting the 100G Datalogging FN Remote ERT Module
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 14
Proprietary and Confidential
Mounting the ERT Module on a Wall or Other Flat Vertical Surface
To mount the 100G Datalogging FN remote ERT module on a wall or other flat vertical
surface
Note For easier installation, you may drill three pilot holes in the mounting surface (use the proper size
drill bit to accommodate the module mounting screws, see the Drilling Template below). When drilling
pilot holes to mount the 100G Datalogging FN remote ERT module, the holes for the two bottom screws
must be on a horizontal line. If you will mount the module on a sheet metal surface, use the mounting
screws included with the 100G Datalogging FN remote ERT module mounting kit. Use a comparable
wood screw to mount the module on a vertical wood surface.
Carefully select a mounting location free from electrical wires. The mounting location must have the
proper clearance to accommodate the 1-1/2-inch module mounting screws so nothing is damaged by the
drill or mounting screws.
100G Datalogging FN Remote ERT Module drilling template
A 3 inches
B 1-11/16 inches
C 3-3/8 inches
1. Using the three 1-1/2-inch mounting screws from the Remote Mount Installation Kit, turn the mounting
screw for the mounting lug (top of module) part way into the mounting surface.
2. Place the 100G Datalogging FN remote ERT module mounting lug recess (on the top of the module's
backplate) just under the screw head. Slide the module upward until the screw head fits completely inside
the mounting lug recess. Several adjustments may be necessary to properly position the screw for module
mounting.