User's Manual

Mounting the 100G Datalogging FN Remote ERT Module
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 13
Proprietary and Confidential
To install tamper seals and cable ties
1. Place the new tamper seals from the Remote Mount Installation Kit over the 100G Datalogging FN remote
ERT module mounting screws.
2. Firmly push both tamper seals all the way into place with a 1/4-inch nut driver or similar blunt tool.
Note A tamper seal is fully seated when the top of the tamper seal is approximately 1/16 inch below the
top of the screw recess.
3. Gather any excess ERT module cable. Loop a cable tie around the pipe and excess module cable.
4. Insert the chiseled end of the cable tie into the locking end and pull the cable tie tight. Cut off and properly
dispose the excess cable tie.
100G Datalogging FN remote ERT module pipe mount installation is complete.