User's Manual

100G Datalogging FN ERT Module
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 5
Proprietary and Confidential
Installation Prerequisites
The following tools are required to install, program, and check the 100G Datalogging FN remote ERT
module. Some specific tools may be required dependent on meter or instrument type.
Medium flat-blade screwdriver
Small flat-blade screwdriver
Medium Phillips screwdriver
Hand pliers
Side-cutting pliers
1/4-inch nut driver or similar blunt tool
One-inch width putty knife
Adjustable wrench
3M Scotchlock E-9Y crimping tool, 3M Scotchlock E-9C cartridge tool, or similar crimping tool
All-weather electrical tape
Size T-10 Torx screwdriver
Itron programming device to program and check 100G Datalogging FN remote gas ERT module
installation and operation:
FC200SR handheld computer with Endpoint-Link or Endpoint-Link Pro software version 5.3 or higher or
Field Deployment Manager (FDM) software version 1.1 or higher
or
FC300 with SRead with Endpoint-Link or Endpoint Link Pro version 5.5 or higher or Field Deployment
Manager (FDM) software version 1.1 or higher
or
900 MHz Belt Clip Radio with Endpoint-Link version 5.5 or higher or Field Deployment Manager (FDM)
software version 1.1 or higher and a customer-supplied laptop
Note Reference the appropriate programming guide or specification sheet for correct software
version (see Related Documents on page 2).