User's Manual

Diaphragm Meter Installation
TDC-0824-003 100G Datalogging FN ERT Module Installation Guide - Remote Mount 59
Proprietary and Confidential
13. Thoroughly apply acetone to the area where you will install the encoder. Do not touch the cleaned area of
the index face before the encoder is installed.
14. Slide the thin end of the encoder spacing tool down over the magnet hub.
15. Peel the strip of protective plastic off the adhesive side of the module's encoder.
Important You must do the next two steps exactly as described or the 100G Datalogging FN remote
ERT module will not work properly.
16. Press the curved side of the encoder firmly against the side of the encoder spacing tool as shown below,
with the adhesive side down.