User's Manual

National/Lancaster Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 44
Proprietary and Confidential
5. If the index has mounting legs, verify each leg is parallel to the back of the index (as shown) to ensure the
correct alignment between the endpoint and meter.
6. Verify the index wriggler is parallel to the index surface.
Caution User only dial-type indexes from National (or
Actaris/Schlumberger/Sprague) Meter with the 100G Datalogging gas endpoint.
7. Attach indexes without mounting legs to the endpoint's index housing mounting posts (as shown below)
using Itron screws SCR-0037-001 .
Attach indexes with mounting legs to the endpoint's index bracket mounting posts (as shown below) using
Itron screws SCR-0015-001.