User's Manual

TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 85
Proprietary and Confidential
B3 CTR Meter Size
B3 CTR Meter Drive Rate
B3 TC Meter Size
B3 TC Meter Drive Rate
56M
100
LMMA CTR Meter
Size
LMMA CTR Meter Drive
Rate
LMMA TC Meter Size
LMMA TC Meter Drive
Rate
1.5M
10
1.5M
50
3M
10
3M
50
5M
10
5M
50
7M
10
7M
50
11M
10
11M
50
16M
100
16M
500
S3A CTR Meter Size
S3A CTR Meter Drive Rate
S3A TC Meter Size
S3A TC Meter Drive Rate
1.5M
10
1.5M
100
3M
10
3M
100
5M
10
5M
100
7M
10
7M
100
11M
10
11M
100
16M
100
16M
1000
Caution Drive rates in these tables are for direct-mount residential style endpoints only
(NOT commercial or remote endpoints).
Note S3A rotary meters are LMMA meters retrofitted with a Series 3 accessory.
Installing the Residential 100G Datalogging Gas Endpoint
Assembly to the Dresser ROOTS
®
Rotary Meter
After 100G Datalogging gas endpoint programming is complete, attach the endpoint assembly to the Dresser
ROOTS
®
Rotary Meter. This mounting procedure applies to B3 CTR/TC, LMMA CTR/TC, and 8C15 series
Dresser ROOTS
®
Meters.
To attach the 100G Datalogging gas endpoint
Refer to Installation Examples on page 81.
1. The 100G Datalogging gas endpoint must be mounted on the adapter plate in an upright position. Align
the 100G Datalogging gas endpoint wriggler with the opening between the tabs of the adapter's drive dog.
Insert one endpoint mounting screw and tighten enough to hold the endpoint. Do not completely
tighten.
Insert the second mounting screw and tighten two turns.
Insert the third mounting screw and tighten two turns.