User's Manual

Sensus/Rockwell Commercial Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 76
Proprietary and Confidential
2. Remove the screws holding the aluminum box to the meter.
3. Carefully remove the aluminum box and set it aside. You will use it later in this installation.
Program the 100G Datalogging Sensus/Rockwell Commercial endpoint before attaching it to the
Sensus/Rockwell meter (see Programming the 100G Datalogging Commercial Gas Endpoint on page 70).
To install the 100 Datalogging commercial gas endpoint on a Rockwell 750 meter with an
Aluminum Box Direct Reading (VDR) Index
1. Using a side-cutter, remove the two rear housing pins from the 100G Datalogging commercial endpoint.