User's Manual

Sensus/Rockwell Commercial Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 74
Proprietary and Confidential
6. Place new tamper seals over screws (if mounting plate has tamper seal cups) and press into place with an
11/32" nut driver or similar blunt tool. If your mounting assembly requires a utility-approved wire seal,
pass wires through holes in the screw heads and crimp the approved wire seal.
This completes installation of the 100G Datalogging commercial gas endpoint on the Sensus/Rockwell
commercial diaphragm meter.