User's Manual

Sensus/Rockwell Commercial Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 70
Proprietary and Confidential
Programming the 100G Datalogging Gas Endpoint
Program 100G Datalogging gas endpoints using:
A FC200SR handheld computer with Endpoint-Link
®
or Endpoint-Link Pro version 5.3 or higher or
A FC300 with SRead handheld computer with Endpoint-Link or Endpoint-Link Pro version 5.5 or higher
or
A 900MHz Belt Clip Radio with Endpoint-Link version 5.5 or higher and a customer-supplied laptop. The
Belt Clip Radio connects to the user-supplied laptop using a USB cable or Bluetooth.
See the Endpoint-Link v5.3 (or higher) Endpoint Programming Guide (TDC-0744) for more complete
programming information.
FC200SR FC300 with SRead 900MHz Belt Clip Radio
Caution The 100G Datalogging commercial Sensus/Rockwell endpoint must be
programmed before use. Follow the steps in this section to properly program the
endpoint.
Take note of the index drive rate shown on the index. The endpoint is programmed based on the drive rate.
Sensus/Rockwell commercial meter index drive rates may be 5-, 10- or 100-cubic feet. The seven-dial index
shown is a 100-cubic feet drive rate.