User's Manual

Sensus/Rockwell Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 23
Proprietary and Confidential
Programming the 100G Datalogging Gas Endpoint Assembly
100G Datalogging gas endpoint s can be programmed using:
A FC200SR handheld computer with Endpoint-Link
®
or Endpoint-Link Pro version 5.3 or higher or
A FC300 with SRead handheld computer with Endpoint-Link or Endpoint-Link Pro version 5.5 or higher
or
A 900MHz Belt Clip Radio with Endpoint-Link version 5.5 or higher and a customer-supplied laptop. The
Belt Clip Radio connects to the user-supplied laptop using a USB cable or Bluetooth.
See the Endpoint-Link v5.3 (or higher) Endpoint Programming Guide (TDC-0744) for more complete
programming information.
FC200SR FC300 with SRead 900MHz Belt Clip Radio
Caution The 100G Datalogging gas endpoint must be programmed before use. Follow
the steps in this section to properly program the endpoint.
Take note of the index drive rate shown on a lower left dial on the index. The endpoint is programmed based
on the drive rate. Sensus meter index drive rates are 2-cubic feet or 0.05 cubic meters.