User's Manual

Sensus/Rockwell Meter Installation
TDC-0823-005 100G Datalogging Installation Guide - Direct Mount 21
Proprietary and Confidential
To assemble the 100G Datalogging gas endpoint and index
1. Separate the 100G Datalogging gas endpoint housing from the cover by pulling the cover straight out from
the housing. Set the endpoint cover aside where it will not be damaged or fill with rain, dirt or snow. The
cover is used later in this installation procedure.
2. Place the index drive gear (1) in the housing wriggler gear cup (2) of the endpoint. The example shows an
11-tooth drive gear. Your index may be a 16- or 18-tooth gear. Use the appropriate 100G Datalogging gas
endpoint for your specific meter. See the Meter Compatibility List on page 2 for more information.
3. After the drive gear aligns with the wriggler gear, the mounting holes line up.