User's Manual

Installing the 100G ERT Module
Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters 41
Assemble the ERT Module
The next step in the 100G ERT Module installation is to create the endpoint module
assembly by attaching the endpoint backplate and cover to the meter index.
To Separate the Cover from the Backplate
1. Obtain a new 100G ERT Module.
2. Place your thumb in the notch on the bottom of the endpoint to hold the backplate and
pull the cover away from the backplate.
You can also separate the cover from the backplate by gently pulling on the wriggler
until the backplate comes free.
3. Set the cover aside where it won't be damaged.
4. Put the index mounting screws about two turns into the backplate index mounting
posts.