User's Manual

Installing the 100G ERT Module
Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters 31
7. Slide the ERT cover over the index and backplate.
8. Verify that the cover is installed correctly.
Next, program the ERT module.
Program the ERT
The ERT must be programmed using the FC200SR with EndPoint-Link software. See the
Endpoint-Link ERT Programming Guide (TDC-0411) for more information.
IMPORTANT You must perform the following programming procedure for
the ERT module to function properly.
Sensus meters. Sensus meters have a 2-foot drive rate, as indicated in the example below
(1), or a 0.05 cubic meter drive (not shown).