User's Manual

Chapter 1 Introduction
2 Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters
Specifications
The functional and operational specifications for the 100G are listed below.
Functional Specifications Description
Power Source
Two "A" cell lithium batteries
Tamper Detection
Tilt tamper and magnetic tamper
FCC Compliance
Part 15 certified
Industry Canada Compliance
RSS-210 certified
Intrinsically Safe per
UL Class I, Division 1, Groups C and D
Product Identification
Numeric and barcoded ERT module type and serial
number
Construction Materials
Gray polycarbonate housing and back plate with
encapsulated electronics
Operational Specifications
Description
Operating Temperatures
-40° to 158° F (-40° to +70° C)
Operating Humidity
5 to 95 percent relative humidity
Program Frequency
908 MHz
Transmit Frequency
Spread spectrum 908 to 924 MHz ISM band
Data Integrity
Verified in every data message
Meter Compatibility
The following meters are compatible with the 100G. Due to continuous research, product
improvements, and enhancements, Itron reserves the right to change this list at any time.
NOTE On rare occasions the location of ERT-to-meter mounting holes on older
diaphragm gas meters might not match up with the mounting holes on the 100G
ERT Module. This can prevent the 100G ERT Module from properly mounting to
the meter.
To ensure you have the latest Meter Compatibility list available, contact your Itron
representative.