User's Manual

Chapter 2 American Meter Installation
18 Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters
Program the ERT Module
The ERT must be programmed using the FC200SR with EndPoint-Link software. See the
Endpoint-Link ERT Programming Guide (TDC-0411) for more information.
IMPORTANT You must perform the following programming procedure for
the ERT module to function properly.
You must program the meter based on the drive rate shown on the index.
Examples of 1-foot (1) and 2-foot (2) drive rates are shown. (The 0.05 cubic
meter drive rate is not shown.) You must program the ERT based on the drive
rate indicated on the index.