User's Manual

Installing the 100G ERT Module
Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters 13
Assemble the ERT Module
The next step in the 100G ERT Module installation is to create the endpoint module
assembly by attaching the endpoint backplate and cover to the meter index.
To assemble the ERT module
1. Hold the new 100G ERT Module.
2. Separate the ERT module backplate from the cover.
3. Place the new ERT index cover where it will not be damaged. The index cover must
not get filled with dirt, rain, or snow; or fall to the ground or floor. The ERT index
cover will be used later in this procedure.
IMPORTANT Before continuing with the installation, note the following
information about American Meter indexes.