User's Manual

Installing the 100G ERT Module
Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters 53
Installing the 100G ERT Module
There are four steps to installing the 100G ERT Module on a meter:
Remove the index
Assemble the 100G ERT Module
Program the 100G ERT Module
Attach the 100G ERT Module to the meter.
NOTE Properly dispose of all unused screws, old index covers, gaskets, tamper
seals, and other left over materials. Do not leave any materials on customer
premises.
To remove the index
The first step to install a 100G ERT Module on the meter is to remove the index from the
meter.
1. Remove any tamper seals from the meter.
2. Remove the two screws and dispose of them properly.
3. Remove the index cover from the meter.