User's Manual

Chapter 6 American/Actaris Commercial Meter Installation
64 Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters
To remove the index
1. Note the orientation of the index. Remove the tamper seals or wire seals from the
index cover and the mounting plate screws.
For illustrative pu
rposes in the procedure, a plastic index mounting plate with
tamper seal cups was used.
2. Remove the index cover screws from the meter. Verify they are 1/2-inch long and not
corroded.
If the screws are the correct length and not corroded, keep them for later use.