User's Manual

Installing 100G ERT Module on ROOTS Rotary
Natural Gas Solutions 100G Installation Guide for Direct Mounting on Meters 87
Installing 100G ERT Module on ROOTS Rotary
The information in this section guides you through the installation of the 100G ERT Module
Commercial on ROOTS rotary meters.
Installation Prerequisites
Installation requires the following items:
One index mounting plate
Gasket and drive cover kit
100G ERT Module
A flat screwdriver
NOTE For illustrative purposes, an American/Actaris ERT is used in this
procedure. The procedure for installing a Sensus Rockwell commercial ERT is
exactly the same.
To attach the Commercial 100G ERT Module to the meter
1. Install the gasket and cover on the index mounting plate (as shown) using the two
screws included with the kit.