User's Manual

Installing the 100G ERT Module
A gap at the screw locations is normal both before and after the index cover
mounting-plate screws are tightened.
7. Install the four ERT module mounting screws and tighten them, in a diagonal
sequence. Turn each screw 1/4 to 1/2 turn after it contacts the mounting plate. If you
are using a torque wrench, tighten to 72 inch-pounds.
8. Place new tamper seals over screws and press the seals into place with an 11/32 inch
nut driver, or other blunt tool.
To attach the index and cover
1. Get the gasket you removed and place it on the index cover mounting plate.
Natural Gas Solutions 100G Installation Guide 67