User's Manual

Chapter 2 American Meter Installation
Program the ERT Module
The ERT must be programmed using the FC200SR with EndPoint-Link software. See the
Endpoint-Link ERT Programming Guide (TDC-0411) for more information.
IMPORTANT You must perform the following programming procedure for
the ERT module to function properly.
When programming the ERT module, you must take note of the drive rate shown on the
index of the meter. Program the meter based on the drive rate shown on the index.
American meters. Examples of 1-foot (1) and 2-foot (2) drive rates are shown below (a 0.05
cubic metre drive rate is not shown). Be sure to program the ERT based on the drive rate
indicated on the index.
1
2
To program the ERT module
1. Using the FC200SR, program the reading of the index that was on the meter into the
ERT module assembly.
22 Natural Gas Solutions 100G Installation Guide