User's Manual

Installing the 100G ERT Module

8. Verify that the cover is installed correctly.

Once combined, the ERT backplate, meter index, and ERT cover create an "ERT

Module Assembly."

Next, program the ERT module.

Program the ERT

The ERT must be programmed using the FC200SR with EndPoint-Link software. See the

Endpoint-Link ERT Programming Guide (TDC-0411) for more information.

IMPORTANT You must perform the following programming procedure for

the ERT module to function properly.

When programming the ERT module, you must take note of the drive rate shown on the

index of the meter. Program the meter based on the drive rate shown on the index. Sensus

meters. Sensus meters have a 2-foot drive rate, as indicated in the example below (1), or a

0.05 cubic metre drive (not shown).

To Program the ERT Module

1. Using the FC200SR, program the reading of the index that was on the meter into the

ERT module assembly.

Natural Gas Solutions 100G Installation Guide 35