User's Manual

Chapter 3 Sensus Meter Installation
4. Attach the right-hand mounting screw to the index and meter, just far enough to hold
the index in place. Use one 6 - 32 x 5/8-inch screw for this step (you can use an
original mounting screw if it was the correct size and not corroded; otherwise, use the
correct size
Replacement Screw see "Replacement Screws" on page 29).
2
1
5. Install and tighten the left-hand index mounting screw.
6. Tighten the right-hand index mounting screw completely.
7. Slide the ERT cover over the index and backplate.
34 Natural Gas Solutions 100G Installation Guide