User's Manual

Chapter 3 Sensus Meter Installation
• If the screws are 5/8-inch long and are not corroded, keep them for later use.
• If the screws are an incorrect length or are corroded, dispose of them properly.
Use 6 -32 x 5/8-inch screws as described in
Replacement Screws on page 29
instead.
8. Use a putty knife or similar object to completely remove the old index gasket from the
meter (if applicable). All traces of the gasket must be removed before the ERT can be
installed.
Assemble the ERT Module
When installing a 100G ERT Module, the next major step is to create the endpoint module
assembly by combining the endpoint backplate and cover with the meter index. Follow the
procedure below to do so.
To Assemble the ERT
1. Obtain a new 100G ERT module.
2. Separate the ERT module backplate from the cover.
32 Natural Gas Solutions 100G Installation Guide