User's Manual

Chapter 4 Actaris Meter Installation
Only two screws are required to mount the 100G ERT Module. Dispose
of the extra screw properly. Do not leave it on the customer premises.
4. Press new tamper seals into place with an 11/32 nut driver, or other blunt tool.
5.
Attaching the ERT Module to Flat-faced Model 1A Meters
If you want to install a 100G ERT Module on a flat-faced model 1A meter you will have to
use the CFG-0015-001 adapter kit. Obtain the kit from Itron then use the following
procedure to install the kit and the 100G ERT Module.
1. Make sure you have all of the following items in the kit.
2. Remove the drive dog from the meter and replace it with the one from the kit.
50 Natural Gas Solutions 100G Installation Guide