User's Guide

I210 3G SmartMeter User Guide
14
5 Requirements and Compliance
The I2103G SmartMeter is compliant with all applicable Federal Communications Commission (FCC)
requirements. The FCC identification numbers for the I2103G SmartMeter are listed as follows:
FCC identifier: QHC-010102A
IC Identifier: 4393B-010102A
This certification is granted to Itron Inc.
5.1 FCC Grant Statement
The antennas used for this transmitter must be installed to provide a minimum separation
distance of 20 cm from all persons, and must not be co-located or operate in conjunction
with any other antenna or transmitter.
5.2 Compliance Statement (Part 15.19/RSS-210/ICES-003)
NOTICE:
This device complies with Part 15 of the FCC Rules [and with RSS-210 of Industry Canada].
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTICE:
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
5.3 Warning (Part 15.21)
Changes or modifications not expressly approved by GE and Itron Inc. may void the FCC authorization to
operate this equipment.
5.4 RF Radiation Safety Guidelines per Part 2 of FCC Rules and
Regulations
The meter should be installed in a location where there will be a separation greater than 20 cm (8 inches)
from locations occupied by humans.