User's Manual
Table Of Contents
- Foreword
- Important Safety Information
- Contents
- About this Document
- Related Publications
- Product Description
- Features
- Specifications
- Air Interface
- Product Functionality
- Contents
- Integration Goal and Objectives
- Customer Problem Isolation
- Wireline and Wireless Communications
- Design Tips for Serviceability
- Environmental Issues
- Regulatory Requirements
- Contents
- Power Supply
- Host Interface
- Power Management
- Antenna Systems
- Hardware Recommendations
- Battery Selection Criteria
- Contents
- Hardware Integration
- Application Software
- Final Assembly
- Installation
- Troubleshooting
- End User Problem Resolution
- Service Depot Repair
- Contents
- Accessories and Options
- Abbreviations and Acronyms
- Desense Overview
- Desense Measurement Techniques
- Preparing the Device Under Test
- Performance Goals
- Methods of Controlling Emissions
- Antenna
- Summary
- FLEX Application Protocol Licensing
- Licensing
July 23, 2002 5-7
CreataLink2 XT Hardware Integrator’s Guide Testing
Installation
4. Connect the coaxial antenna cable to the data transceiver SMA connector.
Tighten the cable connector at 4-8 in-lbs. of torque (i.e. finger-tight only)
(see Figure 2-6).
Power, and Serial Cable Connection
5. Connect the cables and the power supply to the CreataLink2 XT board
assembly for end-use (see Top of Figure 2-6).
000162-O
Figure 5-1. Dimensional Drawing
G
Seat the SMA mating connector properly. Overtightening the connector could cause permanent
damage to the data transceiver.
1.748
1.457
0.724
0.145
0.023
1.277
3.464
3.740
0.138
0.386
0.302
0.066
0.252
0.382
0.128
0.049
Pin 2
Pin 1