User's Manual
Table Of Contents
- Foreword
- Important Safety Information
- Contents
- About this Document
- Related Publications
- Product Description
- Features
- Specifications
- Air Interface
- Product Functionality
- Contents
- Integration Goal and Objectives
- Customer Problem Isolation
- Wireline and Wireless Communications
- Design Tips for Serviceability
- Environmental Issues
- Regulatory Requirements
- Contents
- Power Supply
- Host Interface
- Power Management
- Antenna Systems
- Hardware Recommendations
- Battery Selection Criteria
- Contents
- Hardware Integration
- Application Software
- Final Assembly
- Installation
- Troubleshooting
- End User Problem Resolution
- Service Depot Repair
- Contents
- Accessories and Options
- Abbreviations and Acronyms
- Desense Overview
- Desense Measurement Techniques
- Preparing the Device Under Test
- Performance Goals
- Methods of Controlling Emissions
- Antenna
- Summary
- FLEX Application Protocol Licensing
- Licensing
2-15 July 23, 2002
General CreataLink2 XT Hardware Integrator’s Guide
Specifications
Software Development Configuration
The CreataLink2 XT data transceiver is connected to an interface board, which can
be connected to a PC, another device or an embedded ICE or JEENI box (see Figure
2-6, bottom).
99137O
Figure 2-6. Configuration Options
Creatalink2 XT
Interface Board
22-pin Header
22-pin Header
JTAG
SMA
(Optional)
Ribbon Cable
Serial
Protocol
Analyzer
3-Amp
Power Supply
PC or device
under test
Backup Batt. or
Transmit Supply
Backup
Power
Main
Power
ICE or
JEENI
Box
ICE Box
Connect
JTAG Cable
JTAG Probe Blk Terminal Blk
(Required for ICE Box
but not for JEENI Box)
DB-9
Embedded
(This setup
enclosed in
the dotted box
is only used
for on-board
application
development)
990137-O
Optional Antenna Kit
or Customer-supplied
connection to SMA connector
on CreataLink2 XT
Main supply power, alternate
power for transmitter/backup
battery supply, I/O, A/D, and
serial interface connection to
CreataLink2 XT.