User's Manual
Table Of Contents
- Foreword
- Important Safety Information
- Contents
- About this Document
- Related Publications
- Product Description
- Features
- Specifications
- Air Interface
- Product Functionality
- Contents
- Integration Goal and Objectives
- Customer Problem Isolation
- Wireline and Wireless Communications
- Design Tips for Serviceability
- Environmental Issues
- Regulatory Requirements
- Contents
- Power Supply
- Host Interface
- Power Management
- Antenna Systems
- Hardware Recommendations
- Battery Selection Criteria
- Contents
- Hardware Integration
- Application Software
- Final Assembly
- Installation
- Troubleshooting
- End User Problem Resolution
- Service Depot Repair
- Contents
- Accessories and Options
- Abbreviations and Acronyms
- Desense Overview
- Desense Measurement Techniques
- Preparing the Device Under Test
- Performance Goals
- Methods of Controlling Emissions
- Antenna
- Summary
- FLEX Application Protocol Licensing
- Licensing
2-13 July 23, 2002
General CreataLink2 XT Hardware Integrator’s Guide
Specifications
JTAG Communication Port
Table 2-5 shows the 8-pin vertical header connector signals.
Accessories
The following accessory options are available for the CreataLink2 XT device:
• External antenna kit
• CreataLink2 XT device interface kit
See Section 6, "Parts Information" and the inside of the back cover for part numbers
and ordering information.
Table 2-5. 8-Pin Vertical Header Connector Signals
Pin Number Signal Name Description
1 B++ ICE power source
2 TMP1 Mode select
3 ARM_TDI JTAG Data in
4 ARM_TRST JTAG reset
5 ARM_TCK JTAG clock
6 GND3 Ground
7 ARM_TDO JTAG Data out
8 ARM_TMS JTAG I/O
➧
It is assumed that the Embedded ICE or JEENI is used to drive these signals for
on-board/embedded applications only.