User Guide

STEP 1: CHARGING YOUR SMARTWATCH
Your smartwatch may be in low battery mode when you
first receive it. We recommend charging your
Smartwatch fully before first use. Battery life and charge
cycles vary based on usage.
• Plug the charging cable into the USB port on your
computer or a UL-certified USB wall charger.
• Insert the smartwatch into the appropriate charging
cable section. A charging screen appears on the watch
to indicate that your smartwatch is charging
Your smartwatch takes about 1-2 hours to fully charge.
REPLACING OR CHANGING THE WATCH BAND
To remove the existing strap:
• Turn the watch, face down
• With your finger pull the pin to the left and gently pull the band
away from the watch. The band should easily come detached
from the watch.
Attaching a new band:
• Line up the steady pin with the hole on the base of the case.
• While carefully holding the band in place, pull the lever on the
band to retract the pin down and position the band against the
case to line up the pin.
• Release the lever so the pin snaps in place.
• Repeat these steps for the other strap
STEP 2: SET UP YOUR SMARTWATCH
To set up your new smartwatch, download our free
mobile app by scanning the QR code below.
Open the app on your phone, tap the watch icon on the
upper right and follow pairing instructions. Once
finished, the correct time and date will appear on your
watch.
NOTE: Pairing must be done using the mobile app and
not with your phone’s native Bluetooth.
QUICK START GUIDE