Specifications

www sziton com
RW6852S-50
V1.2 - May, 2022
. .
ITON Technology Corp.
Page 22 of 22
The OEM must comply with the FCC labeling requirements. If the module’s label is not visible when installed, then an
additional permanent label must be applied on the outside of the finished product which states: “Contains transmitter
module FCC ID:VYV-RW6852S- 50B2 ”.
Additionally, the following statement should be included on the label and in the final product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interferences, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.” The module is limited to installation in applications. Separate approval is required for all other operating
configurations, including portable configuration with respect to Part 2.1093 and different antenna configurations. A
module or modules can only be used without additional authorizations if they have been tested and granted under the same
intended end ‐ use operational conditions, including simultaneous transmission operations. When they have not been
tested and granted in this manner, additional testing and/or FCC application filing may be required. The most
straightforward approach to address additional testing conditions is to have the grantee responsible for the certification of
at least one of the modules submit a permissive change application. When having a module grantee file a permissive
change is not practical or feasible, the following guidance
provides some additional options for host manufacturers. Integrations using modules where additional testing and/or FCC
application filing(s) may be required are: (A) a module used in devices requiring additional RF exposure compliance
information (e.g., MPE evaluation or SAR testing); (B) limited and/or split modules not meeting all of the module
requirements; and (C) simultaneous transmissions for independent collocated transmitters not previously granted together.
This Module is full modular approval, it is limited to OEM installation ONLY. Integration into devices that are directly or
indirectly connected to AC lines must add with Class II Permissive Change. (OEM) Integrator has to assure compliance of
the entire end product include the integrated Module.
Additional measurements (15B) and/or equipment authorizations (e.g. Verification) may need to be addressed depending
on co-location or simultaneous transmission issues if applicable. (OEM) Integrator is reminded to assure that these
installation instructions will not be made available to the end user