TPF30 TWF30 INDUSTRIAL FANS OPERATOR’S MANUAL TPF 30 TWF 30 30" PEDESTAL FAN 30" WALL FAN BEFORE USE, ENSURE EVERYONE USING THIS MACHINE READS AND UNDERSTANDS ALL SAFETY AND OPERATING INSTRUCTIONS IN THIS MANUAL . Serial #............................................ Date of Purchase............................ www.itmtools.com.
TPF30 TWF30 ITM INDUSTRIAL FANS LIMITED WARRANTY In addition to any warranties or conditions implied by applicable Statute or Regulations, Industrial Tool & Machinery Sales warrants all of its products against defective workmanship and faulty materials for a period of twelve (12) months from the date of purchase, unless otherwise stated.
ASSEMBLING DIAGRAM PEDESTAL FAN 1. Assembling The Base To The Adjustable Pipe • While holding the base (9) on its side; Push the pipe into the base (9) (Fig 1a). • To secure the pipe to the base (9); locate the supplied 19mm bolt and washer and fit it through the center of the base weight and firmly tighten with a 19mm spanner (not supplied) (Fig 1b), (Fig 1c). 2.
ASSEMBLING DIAGRAM WALL FAN 1. Mounting The Wall Fan To The Wall • CAUTION: The fan must be used in the upright position and right fastened to the wall. • Determine the desired location of the wall fan and ensure that your wall structure is capable of handling the additional load of the mounted product. • Mark the three screw holes with a pencil by holding the hanging bracket (9) to the wall. • Note: Ensure the 2 holes on the hanging bracket (9) holes are horizontal prior to drilling.
SAFETY INSTRUCTIONS 1. If an electrical fault is detected or the power supply cord is damaged, the device must sent to a licenced electrician for repair. 2. Guard against electric shock, avoid body contact with earthed or grounded surfaces eg. pipes, air con, refrigerators etc. Never operate the device in rain or wet conditions, or if the tool has been exposed to rain or wet conditions. 3. Power source; ensure that the power source to be used conforms to the power requirements specified on the name plate.
OPERATING PROCEDURES 1. Oscillating control; The oscillating structure is shown in the drawing. When the oscilate arm is secured to the centre bolt hole, the fan will not oscillate. When oscilate arm is moved to the off-centre bolt hole, the fan will oscillate 90 degrees. Always ensure the power is turned off before making any oscillating adjustments 2.
