200MM INDUSTRIAL BENCH GRINDER OPERATOR’S MANUAL TM400-200 www.itmtools.com.au Ver: 1.
TM400-200 OPERATOR’S MANUAL TABLE OF CONTENTS Warranty .............................................................................................................................. 2 Safety Information ............................................................................................................... 3 Parts Diagram...................................................................................................................... 4 Parts List............................................
TM400-200 OPERATOR’S MANUAL SAFETY INFORMATION Please read and understand this entire manual before attempting to operate the product. WA R N I N G Improper operation or maintenance of this product could result in serious injury and property damage. Read and understand all warnings and operation instructions before using this equipment. When using air tools, basic safety precautions should always be followed to reduce the risk of personal injury.
TM400-200 OPERATOR’S MANUAL PARTS DIAGRAM 4 www.itmtools.com.
TM400-200 OPERATOR’S MANUAL PARTS LIST DIA. NO DESCRIPTION SPEC. QTY DIA. NO DESCRIPTION SPEC. QTY 1 Philips screw M5x46 4 29 M8x20 2 2 3 Spring washer Left wheel cover 4 1 30 31 4 Hex nut M16-Left 1 32 5 6 60# 200x25x15.88 4 1 33 34 M5x10 6 35 1 36 Stone wheel 36# 200x25x15.
TM400-200 OPERATOR’S MANUAL GENERAL SAFETY RULES FOR OPERATION WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mainsoperated (corded) power tool or battery-operated (cordless) power tool. SAVE THESE INSTRUCTIONS Work Area a. Keep work area clean and well lit. Cluttered and dark areas invite accidents. b.
TM400-200 OPERATOR’S MANUAL Power tool use and care a. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. c.
TM400-200 OPERATOR’S MANUAL n. Keep guards in place and in good working order. With the machine disconnected from the mains supply check that the guards are secure and fitted correctly. Always keep the tool rest as close to the grinding wheel as possible. The gap between the tool rest and the grinding wheel should be no more than 3mm. Do not attempt to grind objects that are too small to hold safely. Do not use the work piece to slow down the grinding wheel once the machine has been switched off.
TM400-200 OPERATOR’S MANUAL GETTING STARTED Accessories The bench grinder is supplied with the following accessories: 2 eye shields with mounting brackets and 2 tool rests CAUTION. Always ensure that the bench grinder is switched off and plug is removed from the power point before making any adjustments. To fit the eye shields locate the nut, screw and washers provided through the slot in the eye shield and hole on the grinding wheel guard and finger tighten.
TM400-200 OPERATOR’S MANUAL TROUBLESHOOTING SYMPTOM Motor will not start. Motor will not start – fuses or circuit breakers tripping or blowing. Motor overheats. Motor stalls (resulting in blown fuses or tripped circuit). Machine slows when operating. Wavy condition on surface of workpiece Lines on surface of workpiece. Burning spots or cracks in the workpiece. CAUSE CORRECTIVE ACTION 1. Low Voltage. 2. Open circuit in motor or loose connections. 3. Blown fuse or breaker. 4.
