User's Manual

QUICK START GUIDE
iTech Wearables
FIND OUR APP
IN YOUR STORE
We recommend plugging the USB charger
into your computer to charge your watch.
Align the metal pins on the charger to the back
of the watch. Clip the charger into place.
CHARGING YOUR WATCH CHARGING YOUR WATCH
Power on: Tap and hold the one-touch button
for 3 seconds.
Power Off: Navigate to the settings menu, tap and
hold to enter this section. Next, navigate to the
‘Power Off’ screen. Once there, simply tap and hold
the one touch button on the ‘Power Off’ screen to
turn off your device.
HOW TO TURN ON/OFF
To navigate through the features of your device, tap
on the one touch button. Simply tap and hold the
one touch button to activate a feature.
ENJOYING YOUR
ITOUCH ACTIVE 2
SYSTEM REQUIREMENTS
(Android 9.0 and up) (iOS 13.0 and up)
Make sure your phone’s Bluetooth is turned on and enabled.
For user manuals, please visit
https://www.itechwearables.com/
Scan the QR Code to download the
smartwatch app. Follow instructions in the app
to begin connecting your smartwatch.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital d
evice, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television re
ception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure require
ment. The device
can be used in portable exposure condition without restriction.