Instruction Manual

3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: [phone]
itc-us.com
3. Please review the considerations below to ensure a successful installation.
Only bend the wireDo not bend right at solder joint
Do not horizontal bend to a radius of less than 11.8”
R11.8”
Do not bend flexible light at 90° Do not bend to a radius of less than 1/2”
R0.59”
Do not axial bend to the height
of more than 0.312” within 0.78”
segment
0.78”
Less than 0.312”
Do not twist more than 90° over the
length
of one 24V segment / Two 12V segments
(4” total length)
4”
Axis
*RNLL flexible lighting cannot be field cut. Field cutting the light will void the warranty.
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00217 • Rev B • 12/14/22
Page 2 of 2