Owner manual

E.1
Appendix E
Default Settings
This section describes factory default settings for the IRMA TruPoint
blood analysis system.
DEFAULT SETTINGS: TABLE E-1
Refer to Section 7 (System Settings) for instructions on establishing
IRMA TruPoint system settings. The factory default system settings are as
follows:
Category Default Setting
User ID Settings
• QA User ID 123456
• User ID Off
• User ID on printout Off
Device Settings
• Beeper On
• Communications Communications Method - Serial
Results Transfer - Off
Results Transfer Destination - idms
Automatic Results Transfer - Off
Automatic Device Update - Off
• LAN 10/100 (if applicable): IP Address: 0.0.0.0
Gateway: Off
Gateway IP Address: 0.0.0.0
Subnet Mask: 255.0.0.0
Remote IP Address: 0.0.0.0
Remote Port: 3001
• Date Format MM/DD/YY
• Date/Time Current ( U.S. CST)
24 Hour Clock
• Auto-Print Results Immediate
• Screen Contrast Middle Setting (5)