Installasjonsveiledning

3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: [phone] • Fax: [phone] • www.itc-us.com • [e-mail] • DOC# 710-00193 • Revision A: 07/30/21
For warranty information please visit www.itc-us.com/warranty
Docking Light Installation Instructions
(Part #: 69728SS)
1. Determine the installation location and drill a 1/2”
hole for the wire. Drill two mounting holes at 1.4” on
center.
2. Using the wiring diagrams below, wire the light to the
incoming 12V DC power. Test the light.
3. Feed the wires back through the hole and push the light into the mounting holes. Use application specic
sealant around the light to prevent any ingress of water. Tighten the nuts on back to hold it in place.
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• It is recommended that fuse protection be added to the positive(+) input.
• Technical Specs:
Voltage: 10 - 14V DC | Current: 0.12A | Wattage: 1.6W
Black (-)
12V DC (+)
Black (-)
Red (+)
Incoming
12V DC
Power
Fuse
Docking
Light
1.4”
PARTS/TOOLS NEEDED:
Docking Light
M4 Hex Nuts
(not provided)
Butt Splice Connectors
(Not Provided)
Power Drill
Application Specic
Sealant
(not provided)