User's Manual

Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Specific Absorption Rate (SAR) information
SAR tests are conducted using standard operating positions
accepted by the FCC with the phone transmitting at its highest
certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level,
the actual SAR level of the phone while operating can be well
below the maximum value, in general, the closer you are to a
wireless base station antenna, the lower the power output.
Before a new model phone is a available for sale to the public,
it must be tested and certified to the FCC that it does not
exceed the exposure limit established by the FCC, Tests for each
phone are performed in positions and locations (e.g. at the ear
and worn on the body)as required by the FCC.
For body worn operation, this model phone has been tested and
meets the FCC RF exposure guidelines when used with an accessory
designated for this product or when used with an accessory that
Contains no metal and that positions the handset a minimum of
1.0 cm from the body.Non-compliance with the above restrictions
may result in violation of RF exposure guidelines.
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: