User's Manual

mio_nyx_EN_UM_V1

*Note: If the screen prompts “Emergency”, this means that you are out of the normal network scope (service

scope), but you can still make the emergency call according to the signal intensity.

2.4 The use of USB data route

The method of using USB data route: Input one of the port into the computer, and then input the other port to the

phone, after that you can transfer the data between the computer and the phone. When you are charging, the icon

for the charge is moving. If the charging is finished, the icon will stop moving. You can use the phone as a U disk

after the phone power off.

The phone supports the USB, you can copy and move the file between the phone and the computer after you link

the USB with the computer. You can view the information in the T-Flash card.

*Note

：

--Please power off the phone before you connect the phone with the computer, after the phone connecting up,

you will find information of the USB on the computer, and then you can read the file into my computer. If

there is not information, you must check your phone’s USB port and insert it again.

--If you connect the phone with computer when the phone is powering on, there are three items displaying on

the phone, you should select the “mass storage”, and then you can copy or move the file between the phone

and the computer.

--After that, you need double click the USB icon in the right corner of the computer, and then select “stop”,

now you can withdraw the USB from the computer and the phone. DO not withdraw the USB from the

computer directly, or the date in the T-flash card will be lost, and it can also damage the phone.

You must do it on the computer which is the Windows2000 or SP2.

2.5 Install and pull out T-flash card

This mobile phone supports T-flash card, which is a kind of multimedia memory card used to increase memory of

the mobile phone. It is so small that you should take cautions to install or pull it out in order to avoid damage. The

method to install/ pull out T-flash card:

1. Power off the mobile phone, set memory card with the metal face downward to the memory card slot.

To pull out the memory card, power off the mobile phone, take out the T-flash.

*Note: The mobile phone does not support hot-plug function of T-FLASH in “power on” mode. Only when the

mobile phone is powered off can T-FLASH be pulled out. Restart up and T-FLASH will come into effect.

When using or editing files stored in the memory card, DO NOT pull out the memory card.