User's Manual

mio_nyx_EN_UM_V1
10
battery charger.
*Note:
--During the charge, the handset should be placed where the ventilation is good and the temperature is between
+5
0
C to +40
0
C. In addition, you should use the charger provided by the manufacturer, for the unauthenticated
chargers may cause danger and disobey the recognition and maintenance clauses of this mobile phone.
--When your mobile phone automatically powers off or displays the warning of “Low Power”, you should
charge the battery in time. In case the battery has not run out before charge, the mobile phone will shorten the
charge time automatically.
--The standby time and call time provided by the manufacturer is based on the ideal working environment.
During the practical use, the battery’s service time changes with the network condition, working environment
and use mode used.
--Before charging the battery, please make sure that the battery is properly inserted and it is forbidden to take it
down during charging. .
--When charge is over, please disconnect the charger with the mobile phone and the battery.
If you do not disconnect the charger with the power supply and the mobile phone, after a long time (about 5 to
8 hours), the power of the battery will drop to a certain level and the mobile phone will resume charge once
again. We do not recommend you to do so, for this will affect the performance and service life of the battery.
--This mobile phone does not support USB port, so you can not connect your mobile phone with PC through
USB, it just use to charging the battery.
2.3 Power on
 Long press Hang Up key to power on the mobile phone and also long press the Hang Up key to power off
your mobile phone.
 If you power on the mobile phone without inserting the SIM card, the mobile phone will prompt you to insert
the SIM card. After the SIM card is inserted, the mobile phone will automatically check whether the SIM card is
ready for use or not.
 Then the screen will give the following prompts:
 -Input PIN (If you have set password for SIM card) (Please refer to the section 4.8.5. “security settings”
for detail operations)
 -Input the mobile phone’s password (if you have set the lock-code) (Please refer to the section 4.8.5.
“security settings” for detail operations)
 When the SIM card is successfully decoded, the mobile phone will automatically search the available network
(the screen displays “search network”)
 Once established connection, the name of the network supplier will appear on the top of the screen. This
means that the mobile phone is in “standby” mode and it is available for used.