User's Manual

20110613_KOL_ENG_SS
Shorter
standby
time
 The standby time is associated with the network system setup.
In this case, you are possibly in place with poor communication.
When the signal is not available, the phone will continue to
search for the base station. This will consume a lot of battery
power, making standby time much shorter. To continue to use,
move to a place with strong signal, or shut down the phone
temporarily;
 Replace the battery with a new battery.
SIM card
error
 If the metal surface of the SIM card is dirty, clean the metal
contact with a clean piece of cloth;
 SIM card has not been properly installed;
 If SIM card is damaged, contact your network service provider.
Unable to
make calls
 Check whether the Dial key is depressed after the number is
inputted;
 Check whether your calls have been barred due to insufficient
mobile phone fee;
 Check whether the SIM card is effective;
 Check whether the call barring function has been set;
 Check whether the fixed dialing function has been set.
Your caller
is unable
to access
to you
 Check that your phone has been started up and accessed to the
network;
 Check whether your phone has been restricted because of
insufficient mobile phone fee;
 Check whether the SIM card is valid;
 Check whether the call barring function has been set;
 Check whether the fixed dialing function has been set.
Unable to
re-charge
the battery
 Not well connected. Check whether the plug is properly
connected;
 Charge the battery under 10 or above 55 . Please change to ℃℃
another environment;
 The battery or battery charge is damaged. If necessary, change
it.
Unable to
set up
some
functions
 Operation errors;
 The network service provider doesn’t support this function, or
you have not applied for this function.
8 FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate