User's Manual

Incoming Call Alert Mode

Vibrate then Ring

Incoming Call Alert Mode

Vibrate and Ring

Preparing Your Phone

1. Installing SIM Card

z Please keep your SIM card away from reach of children.

z Scratches and bends can easily damage the SIM card. Please be extra careful

when installing, removing, handling or storing your SIM card.

z Before installing or removing the SIM card, make sure the phone is switched OFF,

and then remove the back cover and battery.

1. Slide the back covers upward the bottom of the phone until it can be removed.

2. Remove the battery (see Removing Battery).

3. Place SIM cad into the SIM holder.

4. Fit the battery with the metallic contacts at the right bottom comer.

5. Replace the back cover by fitting it to the back of the phone.

Install Battery

(1)Connect the battery’s metal touch points separately with the battery compartment metal

touch points, and enter the battery base to the slot.

(2) Slide the back cover toward the top of the phone to lock the cover into its place.

Remove Battery

Remove the back cover then push toward the bottom of the phone and lift the battery at the

at the top side center to remove.

z Settings and data stored in the phone or SIM card may be lost after the battery is

removed.

4..

Charge Battery

Connect the charger to power supply, and then insert the charger pin into the I/O jack.

Note:

1. When charging, DO NOT removes or takes out the battery to avoid the battery circuit to

burn out.

2. While charging, it is normal that the phone and charger will become hot.

3. If the battery is completely empty, it may take a period of time before the charging icon

appears on the display.

5..

USB Management

When USB cable plugged in, the USB charger function will startup. If there is a memory card

inside the phone, the popup dialog box will ask you reboot the phone to used as a USB Flash

Disk or not.