User's Manual

3.2 Assembling of battery and SIM card
Before your can operate the mobile phone, you should get a valid SIM card from
the service operator, otherwise, you could not make any call except emergency
call.
1) Take out the battery
 Pull down the battery cover
 Take out the battery
2) Assemble SIM card
This mobile phone supports two SIM cards. Insert one or two SIM cards to the
sockets.
3) Assemble battery
Assemble the battery; be careful that the contact metal of the battery should be
consistent with the socket of the mobile phone.
Push up the battery cover as the figure.
3.3 Assembling of memory card
This mobile phone supports T-Flash card, which is a small multimedia memory
card used to increase the memory of your mobile phone. Take care when
assembling or disassembling to avoid the damage.
3.4 Battery Recharge
Connect the charger to a power socket; plug the connector of the charger into the
mobile phone. Then the power level indicator at upper right screen will flash. If
the phone is off when charging, the screen will display “charging” indicating the
battery is being charged. If the phone is deposited for long time, the power
indicator may take some time to appear on the screen. If the power indicator at
upper right screen of the phone displays battery full and stops to flash, it means
that the charging is done. If the phone is off, the screen will display a Charge
Completed indicator. During charge, it is normal if the battery, mobile phone and
battery charger are warm. After the charge, disconnect the mobile phone and
charger.
This phone is just 50% charged when delivery. Please use up the power and recharge
it fully. This is the case with the second recharge. After three repetitions, the battery
can achieve its best performance.
4 Safety Password
4.1 PIN number
By setting PIN number (Personal identification number), it can prevent others from
using your SIM card without authorization.