Operation Manual

EN.9

weather station (default setting is “CH1” – Channel 1)

4. Observe if the Low Battery icon appears on the left of

the outdoor temperature. If yes, replace batteries in

transmitter with fresh batteries.

5. Make sure no other interfering sources are being

used (such as computer monitors, TV sets,

headphones, or speakers) in the path of the signal

from the transmitter. The signal travels in a straight

line; an electrical source near that “line” may cause

interference.

Temperature, humidity, or air

pressure is incorrect

1. Press RESET on the main unit.

2. Make sure your main unit and the transmitter is away

from sources of heat / cold / direct sunshine.

CARE OF YOUR WEATHER STATION

1. Do not expose the unit to extreme temperature, water or direct sunlight.

2. Avoid contact with any corrosive materials.

3. Do not subject the unit to excessive force, dust or humidity.

4. Do not open the inner back case or tamper with any components of this unit.

CLEANING YOUR WEATHER STATION

To clean the weather station, use a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth

lightly moistened with a mild detergent solution. Do not use strong solvents such as alcohol, benzene

or thinner, as these might damage the surface of the unit.

SPECIFICATIONS:

Temperature Range

Indoor +14°F to +122°F (-10°C to +50°C) (display shows HH.H / LL.L if out of this range)

Outdoor -58°F to +158°F (-50°C to +70°C) (display shows HH.H / LL.L if out of this range)

Humidity Range

Indoor 20% - 95%

Outdoor 20% - 95%

Temperature Resolution 0.2°F / 0.1°C

RH% Resolution 1%

Temperature & Humidity measure every 30 seconds

Air Pressure Range 850 hPa to 1050 hPa

Alarm Duration 2 minutes

Snooze Duration 5 minutes

Downloaded from www.vandenborre.be