Operation Manual

EN.8
r
tch with
om one floor of a building to another floor will affect the
acy of your weather station, which should operate at the same altitude all the time. If you move
rent weather condition outside.
PERATURE.
hen the outdoor t mperature show “---": the wireless transmission has been interrupted or lost.
After your weather station is powered up, it will take around 24 hours to become stable. The weathe
icons on the display give a reference to the next 6-12 hours weather conditions. It may not ma
the current weather condition outside.
Remarks: Moving your weather station fr
accur
it to a new location, it will take 12-24 hours to stabilise and be accurate again.
Our weather station provides the next 12-24 hours weather forecast. It may not match with the
cur
IF YOU LOSE THE OUTDOOR TEM
W e
Press and hold the / CHANNEL button and your weather station will start to search for the signal
se check that channel 1 is
from the transmitter. If you continue to lose the outdoor temperature
and display, which could happen in extreme cold weather, try placing the transmitter in a different
location until you have smooth transmission of temperature data. Plea
displayed by pressing the / cannel button.
TROUBLESHOOTING
our weather station clock shows irrelevant iIf y nformation or digits, it maybe affected by electrostatic
from other devices. Use a sharp object to press on the top of the
Problem Solution
discharge or interferences RESET
weather station and also on the transmitter. Your unit will be reset to default settings and you will
need to set the time, calendar and alarm time again.
LCD is blank 1. Pr
2. R
ess RESET on the main unit.
eplace fresh batteries in your weather station.
No Outdoor Temperature 1. Press and hold WAVE on the weath
is displayed
er station.
on (default setting is “CH1” – Channel
traight
2. Press and hold WAVE, then press RESET on the
transmitter.
3. Make sure the correct channel is selected on your
weather stati
1)
4. Make sure no other interfering sources are being
used (such as computer monitors, TV sets,
headphones, or speakers) in the path of the signal
from the transmitter. The signal travels in a s
line; an electrical source near that “line” may cause
interference.
Temperature, or air
pressure is incorrect r main unit and the transmitter is away
sunshine.
1. Press RESET on the main unit.
2. Make sure you
from sources of heat / cold / direct
ARE OF YOUR WEATHER ST
1. Do not expose the unit to extreme temperature, water or direct sunlight.
materials.
ith any components of this unit.
C ATION
2. Avoid contact with any corrosive
3. Do not subject the unit to excessive force, dust or humidity.
4. Do not open the inner back case or tamper w
Downloaded from www.vandenborre.be